Ask a Question

Banner dimensions

0 votes
in Eurobot rules by (0 points)
What if the top of my banner, the part touching the edge of the table is for example 450mm long for the height of 100mm and then for the next 250mm of height it's 500mm long. My banner then fills an area of 500x250 but not in it's full height. Would this be valid?
by (0 points)
Not an official answer:

Yes it would (as you can count the 100x500mm area as part of the banner holding system)

I would take some margin, in case the deployment is not perfect

1 Answer

0 votes
by [Referee] (100k points)
 
Best answer
Good afternoon

As says in the rules : To be valid, the banner displayed must cover at least a full area of  500mm long and 250mm heigh. If the banner is made up of several elements, then for it to be valid, the elements must completely fill the surface provided for the banner.

Please read the rule before asking.
by (0 points)
I'm sorry I don't understand your response. Is it valid or not?
by [Referee] (100k points)
As you said : "My banner then fills an area of 500x250". So yes, the constraint "banner displayed must cover at least a full area of  500mm long and 250mm heigh" is respected, the banner is valid.
Welcome to Eurobot FAQ, where you can ask questions and receive answers from the referees.

Avant de poser une question

Avez-vous bien lu le règlement ?
En entier ?
Avez-vous vérifié que votre question n'a pas déjà été posée ? (et donc répondue ? )

Before asking a question

Have you read the rules correctly?
In full?
Have you checked that your question has not already been asked? (and therefore answered?)
Snow Theme by Q2A Market
Powered by Question2Answer
...